1 Series E87 120i (N46) 5-door
Unfasten screws.
Tightening torque: 26 11 1AZ
.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release screws.
Tightening torque: 26 11 6AZ
.
Bend propeller shaft downwards on center bearing.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Grip clamping sleeve (1).
Slacken nut (2).
Detach retainer (3) downwards using a screwdriver.
Pull cable (4) out of holder.
Installation:
Adjust selector lever
Disconnect plugs (1), remove cables from fixtures and allow to
hang down at side.
Release bolts (2) and remove plate (3).
Tightening torque, 24 11 2AZ
.
RA Removing and installing automatic transmission (6HP19Z) N46
BMW AG - TIS
24.01.2013 06:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
