1 Series E87 120i (N46) 5-door
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cut (1) and cut.
Open weld joints in areas (2).
Installation:
Weld new components in areas (3) additionally.
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cut (1) in accordance with measurement a and
cut rear axle carrier.
Important!
Cut outer metal sheet only.
Measurement a=70 mm from rear axle bushing mounting.
Open weld joints in area (2).
Installation:
Weld in reinforcement plates at severance cuts.
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in area (1).
Installation:
Weld new components in area (2) additionally.
Coupé only:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in area (1).
Installation:
Weld new components in area (2) additionally.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
24.01.2013 08:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -