1 Series E87 120i (N46) 5-door
1
Head airbag holders, screwed
4
Gas generator
2
Retaining clips, head airbag (folding pack)
5
Folding pack, head airbag
3
Ramp, B-pillar
6
End fittings, A- and D-pillars
Release screw (1) from end fitting.
Tightening torques 72 2 05AZ
.
Release screw (2) from folding pack holder.
Tightening torque 72 2 04AZ
.
Installation:
If screws (1) and (2) slip, coat them with Loctite.
Important!
Risk of damage to perforation of fabric tape on holder (3).
Lever out clip-mounted holder (3).
Installation:
A new head airbag must be fitted if the perforation is completely
damaged.
Release screw (1) from end fitting.
Tightening torques 72 2 05AZ
.
Release screw (2) from folding pack holder.
Tightening torque 72 2 04AZ
.
Installation:
If screws (1) and (2) slip, coat them with Loctite.
Important!
Risk of damage to perforation of fabric tape on holder (3).
Lever out clip-mounted holder (3).
Installation:
A new head airbag must be fitted if the perforation is completely
damaged.
Lever out clips (4).
Remove head airbag folding pack (3).
If necessary, release screw (1) and remove ramp (2) on B-pillar
for folding pack.
Tightening torque 72 2 06AZ
.
RA Removing and installing/replacing left or right head airbag
BMW AG - TIS
24.01.2013 14:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -