1 Series E87 130i (N52) 5-door
If necessary, remove heat shield from steering gear.
Release banjo bolts (1, 2).
Disconnect pressure line (4) and return line (3) from steering
gear.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 9AZ
(pressure line).
Tightening torque 32 41 10AZ
(return line).
Release screws (1) and remove brackets.
Release screws (2) and tie up pressure line.
Tightening torque 32 41 11AZ
.
Disconnect plug connection (1).
Build date up to 03/2007: Disconnect plug connection (2) on
cumulative steering angle sensor.
Warning!
Risk of injury!
Tie up steering gear to prevent it from falling down when
disconnecting plug connections.
Important!
Risk of damage!
Do not expose connecting cables to tensile load.
RA Removing and installing/replacing active front steering power steering gear
BMW AG - TIS
27.01.2013 07:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
