1 Series E87 130i (N52) 5-door
51 12 148
Removing and installing (replacing) rear
bumper trim (lower section) (up to 03/2007)
Necessary preliminary tasks:
•
If necessary, remove license plate
Note:
The operation is described on the left side; proceed in the same
way for the right side.
Release screws (1).
Installation:
Make sure wheel arch trim (2) is in correct position.
Release screws (1) on bumper trim (2).
Snap out bumper trim (2) towards rear.
Installation:
Catches (1) and guides (2) must not be damaged.
If necessary, replace faulty metal nuts (3).
RA Removing and installing (replacing) rear bumper trim (lower section) (up to 03/2
BMW AG - TIS
27.01.2013 09:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
