1 Series E87 130i (N52) 5-door
Door cannot be opened if Bowden cable (1) is incorrectly
laid.
Important!
Do not damage door lock seal during removal.
Release screws (1).
Remove door lock (2) from inside.
Important!
To avoid leaking and electrical malfunction:
Pull door lock (2) with special tool into corner (3), see Figs.
R51 3381 and R51 7594.
Installation:
Seal (1) on door lock (2) must not be damaged.
Installation:
-
Install door lock and insert screws (1), do not tighten down.
-
Slide special tool 51 2 190 into opened rotary latch until
latch engages in first stage.
Installation:
-
Pretension door lock (1) with knurled screw (2) until special
tool 51 2 190 just contacts corner points (3).
Important!
To tension door lock (1), it is only permitted to turn knurled
screw (2) by a further 1 to 1.5 turns (max.) (risk of
damage).
Door lock seal must rest uniformly on inner door plate (water
ingress).
-
Tighten down door lock screws, tightening torque
51 22 1AZ
.
RA Removing and installing/replacing door lock in left or right rear door
BMW AG - TIS
27.01.2013 10:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
