1 Series 120i (N43) Convertible
11 78 611
Replacing lambda oxygen monitor sensor
(N43)
Special tools required:
•
11 7 030
•
11 9 150
Warning!
Scalding hazard!
Only perform this task on an engine that has cooled down.
Unclip cable and plug (1).
Disconnect plug connection.
Release oxygen monitor sensor (1) with special tool 11 7 030
in conjunction with 11 9 150 .
Tightening torque 11 78 1AZ
.
Important!
•
When using special tool 11 9 150 in conjunction with
special tool 11 7 030 , 47 Nm on torque wrench scale
corresponds to an actual tightening torque of 50 Nm.
Installation:
RA Replacing lambda oxygen monitor sensor (N43)
BMW AG - TIS
15.01.2013 12:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
