1 Series 120i (N43) Convertible
51 12 ...
Replacing rear bumper trim (M Technic
aerodynamic kit)
Special tools required:
•
00 9 317
Important!
The Instructions on component cementing with double-sided
adhesive tape serve as the basis for this repair instruction and
must be observed without fail.
Remove trim:
Carefully detach trim (1) from rear bumper with special tool
00 9 317 and hot air blower.
Installation:
Pull protective film (1) off trim (2).
Fit trim (2) over guides (3) into associated mountings on bumper
and stick on.
RA Replacing rear bumper trim (M Technic aerodynamic kit)
BMW AG - TIS
15.01.2013 17:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
