1 Series 120i (N43) Convertible
63 21 180
Removing and installing/replacing left or right
rear light
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Partially remove luggage compartment wheel arch trim
•
Remove socket housing for rear light
•
Remove bulb holder for brake/tail light
Release nuts (1, 3, 5), gripping the threaded pin (2) with a
suitable tool in so doing. Tightening torque 63 21 1AZ
.
Remove rear light (6) in outward direction from rear light
base (4).
Installation:
•
Observe tightening sequence:
1.
Tighten nut (1)
2.
Tighten nut (3)
3.
Tighten nut (5)
•
Ensure fitting of sealing washers on outer threaded pins (2)
between rear light (6) and rear light base (4)
•
Make sure sealing frame for rear light is correctly seated on
rear light (6)
•
Make sure gap (outer) is uniform all round between rear
light (6) and side panel.
RA Removing and installing/replacing left or right rear light
BMW AG - TIS
15.01.2013 22:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
