1 Series 120i (N43) Convertible
72 12 050
Removing and installing side airbag (basic
seat)
Warning!
Observe safety regulations for handling airbag modules and
pyrotechnical seat belt pretensioners.
Incorrect handling can cause airbags to trigger, resulting in
serious injuries.
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove front seat
•
Partially detach backrest cover
Important!
Make sure airbag wiring harness is exactly routed when
installed.
Detach cable tie.
Release airbag wiring harness (2) from cable holders on seat
mechanism.
Raise release clip (3) and pull plug (4) out of plug housing (1).
Note:
If necessary, release yellow plug housing (1) from holder on seat
mechanism.
RA Removing and installing side airbag (basic seat)
BMW AG - TIS
15.01.2013 23:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -