1 Series 125i (N52K) Convertible
51 47 440
Removing and installing or replacing rear
carpet on seat pan
Necessary preliminary tasks:
•
Remove left/right front seat
•
Remove rear seat
•
Remove handbrake lever
•
Remove airbag control unit
•
Remove inner entrance cover strips
Version with central bass speaker:
•
Remove central bass speaker trim on left/right
Lever out protective cap (1) on left/right.
Loosen left/right screw (2).
Tightening torque 72 11 05AZ
.
Installation:
Check that spacer bushing (3) and rubber ring (4) are in correct
position.
Pull back cable (1) with cable holder (2).
If necessary, release side trim panel lower section in lower
covered area.
Feed out carpet (3) and remove.
Installation:
Make sure openings for air duct and attachment points are
correctly positioned.
RA Removing and installing or replacing rear carpet on seat pan
BMW AG - TIS
17.01.2013 16:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
