3 Series E30 316i (M40) TOUR
Installation:
Remove plastic thread.
Coat main bearing shells and crankshaft with engine oil.
Place main bearing caps in position with grooves of all caps
on same side.
Align main bearing cap flush with side of bearing seat.
No oil is permitted in the blind bores (danger of cracking).
Replace, wash and oil main bearing bolts.
1.
Tighten the main bearing bolts to joining torque.
2.
Tighten main bearing bolts with special tool 11 2 110 or
with special tool 00 9 120 with torsion angle.
Tightening Torque,
refer to Technical Data 11 11 1AZ
Check axial play.
End float,
refer to Technical Data
If necessary, check the guide bearing shell, crankshaft and engine
block.
RA Replacing all main crankshaft bearing shells (M40/M42)
BMW AG - TIS
19.01.2013 06:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
