3 Series E30 318i (M40) TOUR
Removing front end cover (M40)
Remove tensioning roller (1), drive gear (2) and stabilizing roller
(3).
Installation:
Align drive gear (2) with groove facing the Woodruff key and
push on crankshaft.
Mount washer (3) with shoulder against drive gear and tighten
bolt (4).
For tightening torque 310 Nm.
Screw on nut for tensioning roller only loosely.
Lift out Woodruff key (1) and pull off ring (2).
Unfasten all retaining screws on end cover and remove cover.
RA Removing front end cover (M40)
BMW AG - TIS
21.01.2013 02:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
