3 Series E30 318i (M40) TOUR
Prepare special tool 11 2 080 for measurement of voltage.
(Also refer to operating manual for special tool 11 2 080)
Pull lockpin (1) upwards and set bearing pins to maximum
opening with slide (2).
Set gage needle to "0" and align drag needle with gage needle.
Apply tester between camshaft and small intermediate roller in
such a way that both rollers of tester bear on back of teeth and
center pin is located in a tooth gap.
Press slide (2) in until engagement of the lockpin is noticed.
Set toothed belt tension by turning tensioning roller to 45 scale
units.
Tighten down tensioning roller.
Caution!
The toothed belt tension of 45 scale units is a provisional
value; it must be reduced in the work sequence described
later.
RA Removing toothed belt for camshaft drive (M40)
BMW AG - TIS
21.01.2013 02:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
