3 Series E30 318i (M40) TOUR
Installation:
Tighten new bolts in order of 1 ... 8.
Tightening Torque,
refer to Technical Data 33 12 1AZ.
Drive out key (9) and differential shaft (10).
Installation:
The bore in differential shaft (10) is countersunk on one end.
Drive in key (9) from this end.
Turn out differential pinion gears with drive flange.
Remove differential side gears with shims.
To gauge the shims, install both new differential side gears (1)
with disk springs (3) without shims (2).
Center differential side gears with the drive flange.
RA Replacing differential bevel gears (Type K) - final drive removed -
BMW AG - TIS
21.01.2013 03:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
