3 Series E30 318i (M42) SAL
12 14 525
Replacing sensor for cylinder recognition
(M42, M43)
Switch off ignition.
M42 up to 9/93:
Switch off ignition.
Disconnect plug-in connections at cable duct:
1.
Sensor for cylinder recognition (breakerless ignition
distribution)
2.
Impulse sensor for DME
Release screw on sensor.
Installation:
When installing sensor, make sure that O-ring is correctly
seated.
Unfasten retaining screw on cable guide.
Take electric cables out of guide.
M42 from 9/93 and M43:
Remove upper section of manifold, refer to 11 61 040
Remove cable duct from upper section of manifold, refer to
61 11 051
RA Replacing sensor for cylinder recognition (M42, M43)
BMW AG - TIS
21.01.2013 15:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
