3 Series E30 318is (M42) SAL
11 14 151
Replacing crankshaft radial seal
(transmission side)
Note:
This repair instruction is valid for the following engines:
•
M40 / M42 / M43 / M43TU / M44
•
M50 / M52 / M52TU / M54 / M56
•
S52 / S54
Necessary preliminary tasks:
•
Remove gearbox
•
Drain off engine oil
•
Remove flywheel
Unfasten oil sump screws on transmission end.
Loosen oil pan.
Release screws in end cover at rear.
Carefully detach oil sump gasket from end cover, remove end
cover.
Note:
After removing end cover:
check oil sump gasket for damage.
If necessary, remove oil sump and replace oil sump gasket.
RA Replacing crankshaft radial seal (transmission side)
BMW AG - TIS
22.01.2013 00:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
