Replacing Impulse Sensor on Vibration Damper (M42, M43): Step-by-Step Guide
12 14 520
Replacing impulse sensor on vibration
damper (M42, M43)
Switch off ignition.
M42 up to 9/93:
Switch off ignition.
Disconnect plug-in connections at cable duct:
1.
Sensor for cylinder recognition (breakerless ignition
distribution)
2.
Impulse sensor on the vibration damper
Release screw on pulse generator.
Installation:
Clip electric wire in the guide securely to prevent the wire from
rubbing on drive belt.
Unfasten screw on cable guide.
M42 from 9/93 and M43:
Remove upper section of manifold, refer to 11 61 040
Remove cable duct from upper section of manifold, refer to
61 11 051
RA Replacing impulse sensor on vibration damper (M42, M43)
BMW AG - TIS
22.01.2013 00:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
