3 Series E30 320i (M20) CONVER
12 41 513
Disassembling and assembling starter motor
Note:
Starter motor removed
Removing magnet switch, refer to 12 41 041
Unscrew and remove dust cap (2).
Remove retainer (3), shim (4) and sealing ring (5).
Installation:
Checking end float of armature, refer to Technical Data
If necessary, correct with shims.
Unscrew housing screws and remove cover.
Installation:
Recesses for housing screws and insulating section must fit
with one another.
Check bearing bush and oil before installation.
Lift spring and remove carbon brushes.
Remove retaining plate.
Installation:
Check carbon brushes and collector for wear and repair if
necessary,
refer to 12 41 551
RA Disassembling and assembling starter motor
BMW AG - TIS
22.01.2013 08:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
