3 Series E30 325i (M20) CONVER
Punch mark both bearing caps.
Unfasten screws on both bearing covers and remove bearing
covers (turn if necessary, because the sealing ring grips firmly -
suction).
Caution!
Do not mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if necessary.
Installation:
Tightening Torque,
refer to Technical Data 33 11 2AZ.
Shims (1) are used to adjust axial preload force of final drive
mounting (4000 N) and torsional face runout of crown wheel and
bevel gear.
(2) O-ring
Remove complete differential case.
Caution!
Do not bend the pulse generator wheel.
Lift out lockplate (1).
RA Replacing bearing for input bevel gear (Type M) - final drive removed -
BMW AG - TIS
25.01.2013 23:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -