3 Series E30 Z1 (M20) ROADST
C actual
- 11.50 mm
a
0.20 mm
Master disc A
3.90 mm
- a
0.20 mm
Thickness of shim (X)
4.10 mm
If C nominal is less than C actual, "a" on the shim ring (x) is
added to the value.
The permitted tolerance for dimension (x) is derived from the gage
steps available for shim rings (0.01 ... 0.03 mm).
After determining the shim thickness (x), remove drive pinion.
Caution!
Note make of bearings - this is required to determine the
friction torque.
Remove rear outer bearing race and install with a shim (x) of the
appropriate thickness.
RA Replacing bearing for input bevel gear (Type M) - final drive removed -
BMW AG - TIS
02.02.2013 19:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
