3 Series E36 316g (M43) COMP
Open Front Door:
Place special tool 41 5 033 (gage) in area (A) and check flange
inclination, correcting it if necessary.
Contact surfaces (1 and 2) and test surface (3) must bear
uniformly. Sheet-metal flange (5) must run parallel to test surface
(4).
Distance (E): approx. 2 mm
If necessary, straighten the sheet metal flange using a hard wood
block.
Caution!
Touch up damaged paint finish!
Place special tool 41 5 034 (gage) on roof joint (parallel to
windshield rubber frame) and check flange inclination, correcting it
if necessary. Contact surfaces (1 and 2) and test surface (3) must
bear uniformly.
Sheet-metal flange (5) must run uniformly to test surface (4).
Distance (E): approx. 2 mm
If necessary, straighten the sheet metal flange using a hard wood
block.
Caution!
Touch up damaged paint finish!
RA Aligning front doors
BMW AG - TIS
17.01.2013 15:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -
