3 Series E36 316i (M40) SAL
M40/ M42/ M50/ M52 engine:
Only lower engine and transmission with spindle (2) to such an
extent that cylinder head and manifold do not contact engine
partition wall or heating connections (visual inspection).
M41/M43 engine:
Release knurled screws to lower engine and transmission only to
such an extent that cylinder head and manifold do not contact
engine partition wall or heating connections (visual inspection).
Use a screwdriver to lift out spring (1) from the lug (2) on the
housing and swivel upwards.
Pull out shaft.
Installation:
Apply thin coat of grease to bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Support transmission with workshop hoist.
Unfasten screws.
Caution!
Do not allow transmission to hang on transmission input shaft
when removing and installing, as the clutch disc will be
deformed.
Pull transmission downwards and remove.
Installation:
Always fit screws with washers.
Tightening torque, 23 00 1AZ.
RA Removing and installing transmission (S5D 200G, S5D 250G)
BMW AG - TIS
18.01.2013 04:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
