3 Series E36 316i (M40) SAL
Unscrew holder for centre of gravity suspension.
Installation:
Tightening torque,
refer to Technical Data 24 71 5AZ.
Removing end fire wall,
refer to 61 61 270.
Remove cover (1) for injection line.
Support engine from below prior to removal of the cross member
on the transmission.
Insert special tool 11 0 030 from above into inlet manifold and
secure to retainer on crankcase.
Fit special tool 00 2 200 and attach to special tool 11 0 030.
Tighten spindle (2) up to tension.
Remove cross tube.
Unscrew cross member from body.
Lower transmission by turning the spindle only enough that there
is no contact with the wall or heater connections (check visually).
Installation:
Tightening torque,
refer to Technical Data 24 71 1AZ.
RA Removing and installing automatic transmission (A5S 300J)
BMW AG - TIS
18.01.2013 04:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
