3 Series E36 316i (M40) SAL
35 31 000
Removing and installing clutch pedal
Note:
Remove and install instrument panel trim,
refer to notes in Gr. 51
Remove brake light switch,
refer to notes in Gr. 61
If applicable, remove clutch switch.
Remove retaining plate,
refer to 35 11 000
Take off locking clip for shaft pin of clutch-sensor cylinder.
Version with return spring for clutch pedal:
Disconnect return spring. Push out shaft pin.
Installation:
Grease sliding surfaces.
Version with over-centre helper spring:
Hold clutch pedal tightly, push out shaft pin, pull up clutch pedal
slowly and take off over-centre helper spring.
Installation:
Grease sliding surfaces.
Check for correct seating of spring holder in mounting block!
Assembly of over-centre helper spring:
1 Spring retainer
2 Over-centre helper spring
3 Guide pin
4 Bearing pin
5 Locking clip
RA Removing and installing clutch pedal
BMW AG - TIS
18.01.2013 06:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
