3 Series E36 316i (M40) SAL
Note:
If an airbag module with the airbag plug connection at the rear
is replaced by an airbag module with the airbag plug
connection on the side, it is necessary to observe the
following:
Fit a cable clip at point where airbag module cable emerges
from door wiring harness,
replace adapter lead with flat airbag plug with an adapter lead
with angle airbag plug,
secure adapter lead with cable strap to door wiring harness,
tie back airbag module cable at point of exit from door wiring
harness by the excess length (approx. 5 cm),
this point of exit is located near the door opener (2).
Caution!
Airbag plug on airbag module and plug on adapter lead must
not be subjected to tension!
Lay lead as a loop and do not kink.
To locate, secure lead to door wiring harness with cable strap (1),
the lead must not rattle or scuff!
Secure airbag plug to airbag module with retainer.
Airbag module with connection on side
Take off locking clip.
Detach adapter lead with plug (1) from side airbag module.
Unfasten screws (2).
Remove airbag module (3).
To prevent damage to the plug connector on the airbag module,
the following assembly sequence must be observed:
-
Caution!
Always replace micro-encapsulated screws!
Screw down side airbag module
Tightening torque,
refer to Technical Data 72 12 1AZ
-
Attach adapter lead to side airbag module,
-
Mount retaining clip, replace damaged clip if necessary.
RA Removing and installing/replacing airbag module on left or right front door
BMW AG - TIS
18.01.2013 07:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
