3 Series E36 316i (M43) COMP
Straighten and grind joint surfaces.
Adjust spare outer section of rear apron to fit in vehicle.
Mark out holes for plug welding connecting point for lower lamp
carrier.
Remove outer section of rear apron.
Drill out holes for plug welding connection point for lower lamp
carrier.
Coat all connecting faces of spare parts and body with zinc dust
paint.
Fitting and securing spare outer section on rear apron.
Weld connecting points on outer section of rear apron with:
-
Lower lamp carrier
-
Top of inner section of rear apron
-
Bottom of inner section of rear apron
-
Trunk cover plate
-
Side wall
-
Wheel housing extension
Braze connecting point of lower lamp carrier and grind down.
RA Replacing tail panel outer section (compact)
BMW AG - TIS
18.01.2013 23:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
