3 Series E36 316i (M43) SAL
Remove rear outer bearing race with special tool 33 1 351
/ 356 / 362 / 363.
Caution!
The shim (X) is located below the rear outer bearing race.
This is needed again to adjust the block dimension.
Measure and note down thickness of shim (X) e.g. X = 4.10 mm.
Install old shim (X) in front of rear outer bearing race.
Draw in new outer bearing races with special tool 33 1 373
/ 365 / 362 / 363 / 354.
Pull bevel gear roller bearings off drive pinion with special tool
33 1 300.
Press new taper roller bearing onto drive pinion using special tool
33 1 020.
Caution!
Always only use same make bearings for both.
RA Replacing bearing for drive pinion (Type K) - final drive removed -
BMW AG - TIS
20.01.2013 06:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -