3 Series E36 316i (M43) SAL
The correct thickness for the shim is 3.90 mm.
Caution!
If the difference (D) is positive, the old shim was this much too thick.
If the difference (D) is negative, the old shim was this much too thin.
The permitted tolerance for the shim (A) is derived from the available shim gauges which range from
0.01 ... 0.03 mm.
After determining the shim thickness (x), remove drive pinion.
Caution!
Note make of bearings - this is required to determine the
friction torque.
Remove rear outer bearing race and install with a shim (x) of the
appropriate thickness.
Install drive pinion with a new clamping sleeve (2).
RA Replacing bearing for drive pinion (Type K) - final drive removed -
BMW AG - TIS
20.01.2013 06:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -