3 Series E36 316i (M43) SAL
33 32 083
Removing and installing or replacing a
control arm, bottom
Caution!
After assembly, perform wheel alignment check,
refer to 32 00 150.
Release final drive (without detaching output shafts)
refer to 33 10 010.
Move final drive back as far as possible using special tool
33 4 390.
Support trailing arm.
Unsfasten screw on trailing arm.
Installation:
Tightening Torque,
refer to Technical Data 33 32 11AZ.
Unscrew bolt on rear axle carrier.
Installation:
Tightening Torque,
refer to Technical Data 33 32 15AZ.
RA Removing and installing or replacing a control arm, bottom
BMW AG - TIS
20.01.2013 06:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -