3 Series E36 316i (M43) SAL
34 21 812
Overhauling left or right rear brake caliper
(brake caliper removed)
Note:
Use repair kit, refer to BMW Parts Service
Press off protective plugs (1).
Unscrew guide bolts (2).
Installation:
Only clean guide screws; do not grease. Check guide bolts,
replace if necessary.
Tightening torque,
refer to Technical Data
Dismantle brake caliper and remove brake linings.
Installation:
Before installing springs (4), press out brake lining completely.
Press out piston with compressed air applied through connection
bore.
To protect the piston, fit a protective plate (hardwood, hard felt or
similar) in the caliper duct.
Caution!
10 bar of compressed air produces a force of approx.
1250 N.
RA Overhauling left or right rear brake caliper (brake caliper removed)
BMW AG - TIS
20.01.2013 06:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -