3 Series E36 316i (M43) SAL
Unscrew nut (1) and turn lockpin (2) to adjust height of the hood
lid.
Adjust hood lid to same height as side panels (1).
Check for uniform gap on front panel (2).
Tighten nut.
Check for correct locking of locks and retaining hook, adjusting if
necessary.
Measure and, if necessary, correct the distance (A). This indicates
the amount by which the hood lid protrudes beyond the headlight
lens.
Distance (A): approx. 1.5 mm
Loosen mounting screws (1) sufficiently for expansion nuts (2) to
be turned.
Adjust distance (A) by turning expansion nuts (2) uniformly.
Caution!
Hold expansion nuts tight while tightening mounting screws
(1).
Aiming headlights,
refer to 63 10 ...
RA Aligning hood lid
BMW AG - TIS
20.01.2013 07:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -