3 Series E36 316i (M43) SAL
Raise slide/tilt sun roof lid (1) at back until adjusting levers on
left/right can be lifted out of retaining pin (2) of slide/tilt sun roof lid
(1).
Place lid of slide/tilt sun roof on clean base.
Check zero setting of mechanism:
If necessary, adjust mechanism of slide/tilt sun roof using
transmission or emergency handle (power roof) until dimension
(A) is reached (zero setting).
Distance (A) = 322 mm
Edges (1) and (2) must be aligned.
Note:
If necessary, remove transmission from slide/tilt sun roof
cassette,
refer to 54 12 230 (manual actuation)
refer to 54 13 010 (electrical actuation)
Version with power actuation:
Build status up to 1994:
Turn engine/transmission into neutral position with help of
emergency operator.
Shaft center points, notch and pin must be aligned.
Build status from mid-1994:
Zero setting is no longer visible to naked eye. Zero setting is the
cutout position which can be reached in both directions of rotation
(power-driven). Only approach position on longer travel
(hysteresis).
RA Removing and installing lid on slide/tilt sun roof
BMW AG - TIS
20.01.2013 08:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -