3 Series E36 316i (M43) TOUR
35 11 000
Removing and installing mounting block for
pedals
Note:
Remove and install panel for instrument panel,
refer to Gr. 51 .
Remove brake light switch, if necessary remove clutch switch,
refer to Gr. 61 .
Unscrew and pull out screws (1 and 3). Take off holder for
brake-light and clutch switches.
Place clutch cylinder to one side.
Installation:
Replace self-locking nut of screw (1).
Screw (3) holds retaining plate for clutch and brake-light
switches.
Installation:
Make sure line (2) is laid without kinks.
(1) and (3) = clutch-cylinder screws.
Remove locking clip for shaft pin of clutch cylinder.
Version with return spring for clutch pedal:
Disconnect return spring.
Push out shaft pin.
Installation:
Grease sliding surfaces,
refer to Technical Data.
RA Removing and installing mounting block for pedals
BMW AG - TIS
20.01.2013 14:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -