3 Series E36 316i (M43) TOUR
41 62 014
Adjusting trunk lid to fit (touring)
Note:
Engine hood was fitted and screwed in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Remove finisher.
Unscrew detent buffers on left and right sides of trunk lid.
Check fulcrum pads on lower section of trunk lid lock for damage
and replace if necessary.
Loosen screws (1) on lower section of trunk lid lock until it is just
able to move, enabling it to center itself.
The lower section of the trunk lid lock must not scrape against the
upper section.
RA Adjusting trunk lid to fit (touring)
BMW AG - TIS
20.01.2013 15:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
