3 Series E36 318i (M42) CONVER
Only replacement (complete cover for linkage aperture):
Unfasten screws (1) and (2) with washers.
Pull complete cover for linkage aperture (3) backwards to remove.
Installation:
Screw (2) for plastic.
Only replacement (cover for linkage aperture):
If necessary, lift out clip (1) and slide out sliding section (2), press
locking fixture (3) slightly apart to do so.
If necessary, lift out speed nut (4) and finisher (5).
Only replace:
Unfasten screws (1) with tab washer.
Lift out seatbelt guide (2) and remove.
Installation:
Fit edge protector (3).
Only replace:
Unfasten screw (1) and remove rail (2). Remove clip (3).
RA Removing and installing/replacing left or right rear trim panel (convertible)
BMW AG - TIS
22.01.2013 17:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
