3 Series E36 318i (M42) SAL
Removing crankshaft (M42)
Replace crankshaft, refer to 11 21 501
Unscrew main-bearing caps (1 ... 5) and lift out crankshaft.
Installation:
Bearing caps 1 ... 3 are marked with die-stamped numbers.
Bearing cap 4 has a shoulder on the cap side. Bearing cap 5
is not marked.
Installation:
Ensure that the oil spray jets are used at bearings 2 ... 5.
Installation:
Lubricate bearing shells.
Install crankshaft.
Mount bearing caps 1 ... 5 (bearing No. 1 at camshaft-drive
end) in such a way that grooves of bearing-shell guide are on
one side.
Align bearing caps precisely.
Note:
The thrust bearing shell is installed only in the crankcase at
bearing No. 4
RA Removing crankshaft (M42)
BMW AG - TIS
23.01.2013 08:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -