3 Series E36 318i (M42) SAL
Installation:
1.
Knock sensor, cylinders 1 and 2
2.
Knock sensor, cylinders 3 and 4
Clean the contact surface of the knock sensor on the engine
block.
Note installation position of leads.
Avoid leads chafing against engine carrier.
Angle A = 70
°
Installation:
Interrogate fault memory of DME-control unit, check faults in
memory then cancel fault memory.
RA Replacing knock sensor (M 42)
BMW AG - TIS
23.01.2013 09:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -