3 Series E36 318i (M42) SAL
Press EGS control unit downwards off of spring retainers (1 and
2).
Pull out control unit forward through the opening.
Installation:
Place control unit on left and right rails and slide in inclined
upwards as far as stop.
Swing up control unit in this position and engage in spring
retainers (1 and 2).
Pull plug (1) off of control unit after swinging spring retainer (2)
forward.
Important!
Always switch ignition off before disconnecting or connecting
connector.
RA Removing and installing/replacing EGS control unit (A4S 270R/ 310R)
BMW AG - TIS
23.01.2013 10:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -