3 Series E36 318i (M43) CONVER
26 12 001
Replacing complete propeller shaft centre
mount - version without slide
Remove propeller shaft,
refer to 26 11 000
Mark installed position of front propeller-shaft section to rear
propeller-shaft section.
Caution!
Propeller shaft was balanced in assembled state so that
propeller-shaft sections must not be turned when re-installed.
Unscrew bolt (1).
Pull off front section of propeller shaft.
Installation note:
Assemble propeller shaft in such a way that punch marks are
located on opposite sides.
Secure screw (1) with screw retainer (refer to BMW Parts
Service).
For tightening torque,
refer to Technical Data 26 11 5AZ
Pull off centre mount complete with grooved ball bearing
using a standard puller.
Installation note:
Pay attention to installed direction of dust cover (2).
RA Replacing complete propeller shaft centre mount - version without slide
BMW AG - TIS
24.01.2013 09:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -