3 Series E36 318i (M43) CONVER
Installation:
Install new bolts with Loctite No. 270 and tighten in order of (1
... 8).
Observe tightening torque and torsion angle,
refer to Technical Data 33 12 1AZ.
Extract taper roller bearing on final drive case with special tool
33 1 300 (extractor).
Installation:
Press new cold taper roller bearing inner races in with special
tool 33 1 330.
Lift shaft seals out of both bearing caps.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
24.01.2013 10:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
