3 Series E36 318i (M43) CONVER
Pull convertible top drive rod (2) in direction of travel until it locates
firmly (long slot).
Rotate angle joint in half turns (= 0.75 mm) until the shank screw
can be screwed into the main pillar of the convertible top without
any distortion.
Tighten down angle joint.
Secure length adjustment with lock nut.
Fit screw with washer at back.
Drive rod on clamping bracket:
Replace:
Remove left trunk trim and partition wall,
refer to 51 47 140
and 51 47 151
Disconnect drive units,
refer to 54 34 002
Unfasten screw and washer.
Installation:
Secure screw with Loctite 270 (Source of Supply: BMW
Parts).
RA Replacing linkages (both) for convertible top drive unit
BMW AG - TIS
24.01.2013 13:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
