3 Series E36 318i (M43) SAL
Caution!
If a rubber mount with collar is replaced by a rubber mount
with slot, the replacement must be made in pairs!
Rubber mount with slot:
Pull out rubber mount with special tool 33 3 144 / 33 3 145
/ 33 3 222 / 33 3 227 / 33 3 228 and M12 nut (1).
Position special tool 33 3 228 so that that arrow on special tool
points in withdrawal direction.
Rubber mount with slot:
Mark trailing arm eye as shown in sketch with dot of paint (K).
Rubber mount with slot:
Rubber mount and trailing arm eye must be free of grease.
One slot in the rubber mount must line up with the end of the
arrow on the special tool!
Insert rubber mount in special tool 33 3 228 .
RA Replacing one front trailing arm rubber mount (trailing arm removed)
BMW AG - TIS
25.01.2013 09:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
