3 Series E36 318i (M44) SAL
16 14 600
Replacing tank pressure sensor
Remove rear right wheel,
refer to 36 10 300
Release screws, remove rear right wheel housing trim.
Release plastic nuts (1) and tilt expansion tank downwards.
Note:
Lines remain connected.
Open hose clamp (1) and detach hose. Unfasten plug connection
(2) and disconnect.
Detach tank pressure sensor (3) from both retainers from below.
Installation:
Replace hose clip. Ensure proper locking of plug connector.
RA Replacing tank pressure sensor
BMW AG - TIS
27.01.2013 03:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
