3 Series E36 318i (M44) SAL
18 32 005
Removing and installing / replacing exhaust
catalytic converter (M40, M42, M43, M44)
Disconnect plug connector for Lambda oxygen sensor.
Unclip wires in holder.
Unfasten hexagon nuts.
Installation:
Check seal, replace if necessary.
Replace self-locking nuts.
Coat threads with copper paste CRC, refer to BMW Parts
Service.
Remove exhaust pipe by unfastening the nuts from the
transmission bracket.
Installation:
Wait to mount bracket tension-free until exhaust catalytic
converter has been completely installed.
Unfasten flange connection, disconnect exhaust system and
remove exhaust catalytic converter.
Installation:
Replace self-locking nuts.
Coat threads with copper paste CRC, refer to BMW Parts
Service.
The screw heads must be located on the side of the
compression spring.
RA Removing and installing / replacing exhaust catalytic converter (M40, M42, M43,
BMW AG - TIS
27.01.2013 03:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -