3 Series E36 318is (M42) COUPE
33 33 101
Replacing two rubber mounts for rear axle
carrier (rubber mounts, front)
Caution!
After completion of work, perform chassis alignment check,
refer to 32 00 150.
Unfastening propeller shaft from final drive,
refer to 26 11 000.
Unfasten retaining bracket for handbrake cables.
Remove cable plug (brake lining wear indicator/ABS sensor) from
the protective housings on the rear axle carrier and isolate.
Pull off speedometer signal plug.
Take up rear axle with special tool 33 4 390.
Unfasten screws.
Installation:
Tightening Torque,
refer to Technical Data 33 33 3AZ.
Note:
Damaged threads in bushes on body side can be repaired with
Helicoil thread inserts M 12 X 1.5 X 18. The Helicoil thread
inserts must be fitted flush with the original thread.
RA Replacing two rubber mounts for rear axle carrier (rubber mounts, front)
BMW AG - TIS
28.01.2013 06:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
