3 Series E36 318is (M42) COUPE
Aligning door window and tightening down screw.
Tightening torque, refer to Technical Data 51 32 4AZ
Note:
Check parallelism and mount the rubbing strip.
Caution!
Checking limit stop,
refer to 51 32 ...
Retraction depth (B):
Note:
If gasket makes complete contact with glass and preload level
(D) has been reached, dimension (B) can deviate.
Ideal Adjustment:
Dimension (B) = approx. 1.5 ... 2.5 mm
Dimension (B) is measured approx. 90 and 400 mm before edge
of door window at B-pillar.
Lower door window and remove rubber plugs from bottom of door.
Installation:
Insert the rubber plugs.
Adjust height stops through holes.
Caution!
Measurement (B) is dictated by the door seal, which settles in
the course of time.
Consequently the height stops must be adjusted so that the door
window can be lowered even after failure of automatic lowering.
Checking limit stop,
refer to 51 32 ...
RA Adjusting left or right front door window (coupé and convertible)
BMW AG - TIS
28.01.2013 09:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -