3 Series E36 318is (M44) CONVER
Apply a thin coating of grease to top side of rubber profile gasket
and both sides of special tool 11 2 330.
Place special tool 11 2 330 on top side of rubber profile gasket.
Fit gear case.
Install and tighten all screws.
Tightening torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
Carefully pull out special tool 11 2 330.
Replace radial seal in timing case cover at bottom,
refer to 11 14 141.
Assemble engine.
RA Removing and installing, sealing or replacing timing case (M44)
BMW AG - TIS
03.02.2013 20:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
