3 Series E36 318is (M44) CONVER
11 21 531
Replacing all main crankshaft bearing shells
(M44) (engine dismantled)
Note:
Clean components before installing.
Caution!
Note grinding stage of crankshaft,
refer to Technical Data
Note:
Injection nozzles for cooling the pistons are installed on the
underside of the cylinder between the bearing seats.
In order to avoid the possibity of injury from the piston or
connecting rod, the location of spray nozzles is equipped with
special tool 11 7 320.
Check the setting of the spray nozzles.
Attach special tool 11 7 320 to the intake side in the receiving
bore hole in the engine block.
The spray nozzles must fit into the guide of special
tool 11 7 320.
If necessary, loosen the spray nozzles and adjust and tighten
them using special tool 11 7 320.
Tightening torque,
refer to Technical Data 11 11 7AZ
RA Replacing all main crankshaft bearing shells (M44) (engine dismantled)
BMW AG - TIS
03.02.2013 20:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
