3 Series E36 318is (M44) CONVER
Punch mark both bearing caps. Unscrew and remove both bearing
caps.
Caution!
Do not mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if necessary.
Installation:
Tightening torque,
refer to Technical Data 31 11 2AZ.
Differential housing mounts and torsional face runout are set
using the shims (1).
Check O-ring (2), replace if necessary.
Remove complete differential case.
Caution!
Do not bend the pulse generator wheel.
Remove lockplate.
Unfasten nut (1) and brace with special tool 23 0 020.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
04.02.2013 01:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -